Knitting waves of yarn residues

And again about multicolor knitting without messing up in balls. We will continue to "attach" the rest of the yarn.

There are a lot of names for this technique: partial knitting, shortened rows, swing, but the essence is the same - each colored section is knitted separately and tied into the general canvas without seams.

This technique, although it looks complicated, is actually quite simple. I knit, not counting the loop of additions and increases, I arrange the colored areas like a hand will fall, but, to begin with, to understand the principle, let's make a sample with a bill.

We need multicolored balls and loop markers. You can, of course, buy ready-made ones, but I did not like them - they are very thick, stick out with knitting needles and interfere with normal knitting. Therefore, I have invented a method using dog rubber. Do not be scared :))), these are ordinary latex rezinochki for dog chelochki. Sold in any pet store. They do not interfere with holding the knitting needles and are easy to swing from one spoke to the other.

One color is taken as the basis (you can then without it), I will have a dark blue.The basis of knit facial satin, and colored areas with shawl pattern. Red dots in the diagram are marked markers-rubber band.

  1. recruit 60 loops and knit two rows (front and purl). Clew not cut off.
  2. We tie the following to the blue thread (it is light turquoise for me) and knit the front row to the end.
  3. purl row / (knit light turquoise) edging, 19 faces., no further knitting until the end of the row knitting is overturned (the working thread twists around the last non-knitted loop) and we put a marker on the right knitting needle (dog stitch).
  4. (knit light turquoise) edging, facial to the end of the row.
  5. purl row / (we knit light turquoise) edging, 13 faces., not knitting until the end of the row knitting is turned over (the working thread twists around the last untied loop) and we put a marker on the right knitting needle.
  6. (knit light turquoise) edging, facial to the end of the row.
  7. purl row / (we knit light turquoise) edging, 8 faces., then without knitting to the end of the row knitting is turned over (the working thread twists around the last not tied loop) and we put a marker on the right knitting needle.
  8. (knit light turquoise) edging, facial to the end of the row.
  9. purl row / (we knit light turquoise) edging, 4 persons, then without knitting until the end of the row knitting is turned over (the working thread twists around the last non-knitted loop) and we put a marker on the right knitting needle.
  10. (knit light turquoise) edging, facial to the end of the row.
  11. purl row / (we knit light turquoise) edging, 1 person., then without knitting until the end of the row knitting is turned over (the working thread twists around the last untied loop) and we put a marker on the right knitting needle.
  12. (knit light turquoise) edging, facial to the end of the row.
  13. 13: purl row / (knit light turquoise) edging, facing to the end of the row. Rubber in the process of knitting a row from the left knitting needle to the right.

Those. we shortened the light-turquoise section to: 40, 6, 5, 4, 3 loops. Here's what we got:

Next, cut the turquoise thread (respectively, securing) and knit two rows (front and back) with the main color, not forgetting to throw the rubber bands from the left needle to the right one.
Attach the third color (I have it - bright blue).

  1. (knit bright blue) front row to the end.
  2. purl row / (knit bright blue) chrome, 39 purl, then do not knit until the end of the row knitting overturns (working thread twists the last untied loop) and we put a marker on the right knitting needle.
  3. (we will knit bright blue) chrome, purl loops TO MARKER, remove the marker, twist the un-tied loop that went behind the marker with the working thread, turn over the knitting.
  4. purl row / (knit bright blue) purl, not reaching the marker 6 loops we put on a new elastic band (not forgetting to wrap the unwired loop of the previous row with a working thread.
  5. (we will knit bright blue) chrome, purl loops TO MARKER, remove the marker, twist the un-tied loop that went behind the marker with the working thread, turn over the knitting.
  6. purl row / (knit bright blue) purl, not reaching the marker 5 loops we put on a new elastic band (not forgetting to wrap the unwired loop of the previous row with a working thread.
  7. (we will knit bright blue) chrome, purl loops TO MARKER, remove the marker, twist the un-tied loop that went behind the marker with the working thread, turn over the knitting.
  8. purl row / (knit bright blue) purl, not reaching the marker 4 loops we put on a new elastic band (not forgetting to wrap the unwired loop of the previous row with a working thread.
  9. (we will knit bright blue) chrome, purl loops TO MARKER, remove the marker, twist the un-tied loop that went behind the marker with the working thread, turn over the knitting.
  10. purl row / (knit bright blue) purl, not reaching the marker 3 loops we put on a new elastic band (not forgetting to wrap the unwired loop of the previous row with a working thread.
  11. (we will knit bright blue) chrome, purl loops TO MARKER, remove the marker, twist the un-tied loop that went behind the marker with the working thread, turn over the knitting.
  12. 13: purl row / (knit bright blue) edging, facing to the end of the row. Rubber in the process of knitting a row from the left knitting needle to the right.

The second color plot is ready:

Next, we cut off the turquoise thread (fixing it accordingly) and knit two rows (front and back) with the main color (I have dark blue), not forgetting to throw the rubber band from the left needle to the right one.
We attach the fourth color (I have it - turquoise green).

  1. (we knit a turquoise-green) the front row to the end.
  2. purl / green (vyazhem turquoise green) purl to the end of the row.
  3. (we knit a turquoise-green) the front row to the first marker. Marker remove and knitting overturn.
    Repeat 2 and 3 row until we remove all markers.
  4. purl row / (knit turquoise-green) purl to the end of the row. Cloth leveled in height.

Thus knit further colored areas. We arrange them to taste. The length and height of the color areas can be changed as you like.

With this method of rotation remain holes. Personally, I like them, you can beat them with lacing.

but if you don’t want holes, then the turn is carried out like this: turn the work and make 1 nakid on the right knitting needle, and with further knitting the next purl to knit up to the 1st nakida, transfer to an auxiliary needle, pull the next loop as a purse, stretch the thread loop. Then transfer from the auxiliary knitting needles to transfer to the left knitting needle and return the removed loop to the left knitting needle. Tie this loop and nakid together purl.

And you can not change the balls, but take the main color and long-sectioned yarn.



Related News


How to summon a gin
How useful onions
The most recent jokes - you will laugh to tears
Lilac application
How to make real Georgian satsivi